Radeon Instinct MI8 DisplayPort PCIe bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bracket to replace the original which blocks DisplayPort socket.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 113
- Wydruki
- 0
- Wyświetlenia
- 1412
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
Hi everyone.
It's my first upload here so any suggestions for improvements are welcome.
There was this special deal for a Professional-grade Radeon Instinct MI8 (basically a R9 Nano without a fan and with only 1 monitor-out: DisplayPort) for around a €100 and I just could not let it slip by.
The problem is, that the GPU's stock bracket is obstructing the single DisplayPort socket.
I took the XFX RX 550 standard height bracket (by wmlowder) model so I didn't have to start with an empty canvas and went away at modeling. I couldn't find it here on PrusaPrinters and gave up after a few minutes.
The ventilation cutouts are copied by taking a picture of the original bracket, then doing some cleanup and converting it to svg.
Since I'm using Tinkercad (I don't feel comfortable enough with constraint-based modeling) it took a few test prints to get the holes just right.
You can see a few prints with greater thickness - I made those to increase stiffness, but they didn't fit in the PC Case.
I've printed my working piece in Fiberlogy EasyPETG Black.
The file I printed is the MI8_PCIe_Bracket Thin side-mount - it's supported my GPU for a few days now and seems fine.
I also provide a file with thicker side-mount but I haven't actually printed it.
0.4 nozzle
Sliced in Cura at 0.6 outer and inner line width
Support interface line width: 0.26
Other lines at 0.4
I reduce speeds with these settings.
Please take a look at the screenshots if you need to see them.