Roland UM-One MIDI-to-USB Controller mount for 1.5" Drum Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Protect your MIDI controller from careless feet, or just make your setup a little cleaner
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 131
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial
My Alesis eDrums are predominantly used for Clone Hero, and the kids like to have a jam every now and then. Unfortunately they also like to run around and I was worried about them tripping on my dangling wires and breaking something/themselves.
Can be printed without supports depending on how well your printer does bridging. There is a small amount of 90 degree overhangs on the top edge of where the UM-one sits. I printed mine from ASA perfectly fine with no supports.
This clamp should slide onto most 1.5” drum racks, and then clamp down firm using any M6 screw of >20mm you have on hand. The Roland UM-one is a snap fit. The design is asymmetrical and matches the UM-one’s shape, so please pay attention to the “Up” arrow embossed on the inside of the mount and orient the UM-one in that orientation.
I designed this clamp around some M6 prevailing torque nuts I had on hand and they were a press fit. If you have any issues I’ve also included the .step and .f3d files for you to make any modifications.