TV06 5015 Bed Fan Duct and Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mod to assist with increasing chamber temps
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 108
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Important: this will interfere with the internal spool holder - you will need to remove it and mount your spools externally.
Print in ASA or higher temp tolerance material. I've added some aluminium tape as added insulation due to proximity to >100C bed.
Print orientation:
Add supports if required on the larger duct opening if bridging is an issue.
Hardware required (per fan):
- 5015 fan
- 2x 20mm M4 (thread into plastic)
- 1x M3 t nut
- 1x 8mm M3 Socket Head
- Wires and connectors to MCU board
Plug into spare fan port (make sure it is controllable).
Example macro here: https://github.com/VoronDesign/VoronUsers/blob/main/printer_mods/Ellis/Bed_Fans/Klipper_Macros/bedfans.cfg
It's not a good idea to run the fan at 100% as it will end up cooling down the relatively weak stock bed heater and trigger an error in klipper.