1 / 2
Nikon camera lid for D3500
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This lid fits on the D3500 camera acting as a replacement lid for the original.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 247
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
My original Nikon D3500 lens cap broke (one of the plastic springs broke apart).
So I decided to remix the D3100 lens cap to one for the D3500 by scaling it up a bit. I installed it not with the printed springs but with actual springs recovered from a pen.
Assembly
- Print the models
- Get yourself a pen spring and some glue
- Cut the spring in half. You might even want to shorten each half a bit that it sticks out not to far. Check this image as to where I have let the spring come (just a mm or 2 before the extended border).
- Glue each pring more or less in the middel (note at this stage my springs are a bit too long, I ended up in disassembling it and cutting them shorter as explained above).
- Then snap in each side, and done ✅
