1 / 5
(SVBONY, ASIAIR, ONSTEP etc.) Vixen rail accessory clamp, 20 mm M4 pattern — zdjęcie 1
1 / 5

(SVBONY, ASIAIR, ONSTEP etc.) Vixen rail accessory clamp, 20 mm M4 pattern

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple two‑point clamp for standard Vixen rails. Top face has 2× M4 mounting holes at 20 mm spacing for accessories

Ocena
0 / 5
Polubienia
16
Pobrania
94
Wydruki
0
Wyświetlenia
480
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

What it is

A compact two‑point vise for Vixen dovetail rails. Top face has 2× M4 holes at 20 mm spacing for small boxes and controllers. It clamps.

Tested on

Omegon ProRC 6" Carbon with doubled stock Vixen rail (up&bottom). Should fit other Vixen‑style rails.

Fits

SVBONY SV241 power box, OnStep v5 by TerransIndustry, and any accessory using 2× M4 @ 20 mm C‑C. Possibly AsiAir boxes too. And other power boxes.

Hardware (BOM)

  • 2× M3×50 socket head screws
  • 2× M3 square nuts (5.5x5.5x2mm)

Optional thin rubber/TPU pad on the jaw for glossy rails

Printing

Material ASA for UV/heat/cold/extra strength. No supports. 0.2 mm layer. 6 walls. 6 top/bottom. 70% infill gyroid/cubic to protect your pricey gear. Keep the STL orientation to maximize strength, unless you completely trust your prints' inter-layer bonding strength.

Assembly

  1. Press M3 square nuts all the way, so you can see through M3 holes on the sides.
  2. Insert M3×50 screws though the vixen_double_mount_sv241_B part. Tighten alternately to the point those square nuts don't fall out.
  3. Bolt your accessory with 2× M4.
  4.  Slide onto rail. Tighten M3 screws alternately till it clamps on your rail.
  5. Tug test. If it creeps, add a quarter‑turn. If plastic complains, you went too far.

Load & sanity

For light accessories only. Temperature swings could change clamp bite; re‑check before sessions.

Remix

Default is 20 mm spacing. Remix for other patterns if needed; label files clearly.

Changelog

v1.0 — first release, 20 mm M4 pattern.

Tagi