1 / 7
Panasonic 42.5mm f1.7 Lens Hood — zdjęcie 1
1 / 7

Panasonic 42.5mm f1.7 Lens Hood

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a lens hood for the Panasonic 42.5mm f.17 micro four thirds lens. The mount snaps in place like the real lens…

Ocena
0 / 5
Polubienia
10
Pobrania
80
Wydruki
0
Wyświetlenia
658
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial

This is a lens hood for the Panasonic 42.5mm f.17 micro four thirds lens. The mount snaps in place like the real lens hood. It is a little tricky to take off the first time (just like the real ones) but loosens up pretty quickly. It isn't reversible.

The print with the rough surface was done using Cura's Fuzzy surface experimental option and a support blocker to make sure it only printed on the hood part.

Print Settings

Printer Brand:

Creality

Printer:

Ender 5

Rafts:

No

Supports:

Yes

Resolution:

.2mm

Infill:

25%

Filament: eSun PLA Black


Notes:

It took some trial and error to get all the sizes right and printer settings may throw it off. I printed mine on an Ender 5 Pro sliced in Cura 4.6. The important settings were:

Print with the bottom down.

0.2mm Layer Height

0.4mm Wall Line Width

3 Wall Line Count

25% Infil.

Supports Enabled

Horizontal Expansion: 2 (This setting wasn't shown by default but it wasn't generating full supports without it).

This was printable without supports but the fit was way better with them and the amount of supports needed are minimal and only in the first layers.

Category: Camera

Tagi