1 / 6
AT2020+ to Ikea Lanespelare Lamp Boom Arm Connector — zdjęcie 1
1 / 6

AT2020+ to Ikea Lanespelare Lamp Boom Arm Connector

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Connector for mounting an AT2020 microphone to an Ikea Lanespelare lamp boom arm.

Ocena
0 / 5
Polubienia
1
Pobrania
5
Wydruki
0
Wyświetlenia
99
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution — Noncommercial

This model lets you convert an Audio-Technica AT2020 microphone to mount directly onto an Ikea Lanespelare lamp arm, turning it into a budget-friendly and functional microphone boom arm.

The design consists of two printed parts:

  • Ikea Lanespelare connector
  • AT2020+ connector

Once printed, they are joined with a long M6 screw to create a single movable joint. The result is a simple, sturdy and adjustable mount for your microphone.

Instructions

  1. Print the Ikea Lanespelare lamp connector.
  2. Print the AT2020+ connector.
  3. Use a long M6 screw to join them into one movable joint.
  4. Unscrew and remove the lamp head.
  5. Cut the lamp cable near the head and pull the rest out of the arm. Do not power the lamp again.
  6. Bolt the connector assembly to the end of the arm and tighten evenly.
  7. Attach the AT2020 to the 3D printed part using the OEM screw.
  8. Route your XLR cable along the arm, tie it neatly, and leave a small loop at the mic end.
  9. Adjust the arm position, check it holds securely, and test the microphone. Tighten any loose screws if needed.

This setup is ideal for creating a clean recording space without spending extra on an expensive boom arm. The joint allows smooth adjustment, and the cable routing keeps everything tidy.

Tagi