Jonsbo N3 Backplane 10" rack mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
NAS backplane mount for 10" racking.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 65
- Wydruki
- 0
- Wyświetlenia
- 1497
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Jonsbo N3 Backplane Rack Mount
This model is designed to mount the Jonsbo N3 Backplane within a 10-inch rack, providing a secure and space-efficient solution for NAS (Network Attached Storage) system builds. The bracket allows for clean integration of the backplane into a custom rack-mounted NAS chassis or enclosure.
Hardware Requirements:
- 3 × M4×16 mm screws and matching nuts/bolts
Recommended Print Parameters:
- Material: PETG (for enhanced strength, flexibility, and temperature resistance)
- Perimeters/Walls: 4
- Top Layers: 6
- Bottom Layers: 6
- Infill: 20–30% (adjust as needed for rigidity)
Note that holes are not cut all the way though in the print, after running tests with threads i found that leaving them closed and drilling a small pilot hole into the holes and putting the m4 screws in was much better. This results in a tight fit and less vibrations coming from anything else in your rack.
PETG is recommended to ensure dimensional stability under load and during extended operation in warm environments.