1 / 5
Keihin PD Carb Choke Arm And Cover Dust Cap for 1977 Honda XL350 — zdjęcie 1
1 / 5

Keihin PD Carb Choke Arm And Cover Dust Cap for 1977 Honda XL350

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement choke arm for the Honda XL350 and likely others with a Keihin PD Carb

Ocena
0 / 5
Polubienia
1
Pobrania
7
Wydruki
0
Wyświetlenia
79
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Share Alike

About

I bought a fancy metering rod carb for my bike, but it wasnt working right. The stock one worked mostly fine other than the choke no longer working. 

I dont know why keihin used plastic choke arms and failed to make a replacement part for these. They change slightly over the years from metal to plastic to varying revisions of plastic. 

When I got this bike I lacked the knowledge to make this part over again and thought about how I needed to be careful or I risk ruining it permanently, but now we can just make copies. 

Its apparent why the thing would fail either in the spring mechanism or the knarp holder.

Printing

I printed this from Polymaker Fiberon PETG-CF08. It seems more than sufficient, but also have a backup made in polycarbonate.

I should think any filament more substantial than PLA would last a long time here, heck, even PLA might be fine, but it probably gets warm enough behind the engine to melt it. 

You should plan to run a bunch of walls, to basically fill up the whole model, or do 2 walls alternating with solid 100% infill. 

The tolerances are pretty tight on this thing, so if havent done flow calibration and pressure advance calibration, its probably not going to fit well. Even then, I had to trim a little of the seam out in the center. 

Additionally, you can sand/polish the arm just a bit and apply a little grease for proper snappy action. 

If you have questions let me know. If you found this and you dont have a printer, leave a comment or message me, and I can send you a couple printed out for shipping and a few bucks!

Tagi