X Endstop Mod for Voron 2.4 (Common Anomaly UltraLight + LDO Nitehawk SB + ChaoticLab Tap V2)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
X Endstop & Wire Guide for Common Anomaly UltraLight Beam, Nitehawk SB & Tap V2.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 52
- Wydruki
- 0
- Wyświetlenia
- 567
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I designed these parts to solve the X endstop mounting challenge on my Voron 2.4 build, specifically for the combination of the Common Anomaly UltraLight Aluminum X Beam, the LDO Nitehawk SB (umbilical), and the ChaoticLab Tap V2.
Since I wanted a physical X endstop rather than sensorless homing, I needed a way to trigger the switch reliably and route the wiring cleanly to the Nitehawk PCB without snagging.
The Mod consists of two parts:
Endstop Bumper (Target): This small part mounts underneath the right-side X-axis motor mount (XY joint). It acts as the contact point for the microswitch lever.
Wire Guide: This attaches to the two typically unused heatset inserts on the side of the Stealthburner. It routes the microswitch wires safely under the aluminum X beam and guides them directly to the Nitehawk SB ports, keeping the umbilical setup clean.
Installation:
The bumper installs on the right gantry extrusion/mount.
The wire guide bolts onto the side of the Stealthburner.
The X endstop microswitch (Omron D2F or similar) is mounted on the toolhead carriage (adapted for Tap V2) as shown in the photos.
Print Settings:
Material: ABS or ASA
Perimeters: 4
Infill: 40%
Layer height: 0.2mm standard Voron profile.
Happy printing!