Helical Gear Shaft (50T, M0.5, 17° RH) – Dual-Drive Extrude
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bambu P1/P1P Stepper Helical Gear Shaft (50T, M0.5, 17° RH) – Dual-Drive Extruder Upgrade for Voron / Kossel / CoreXY
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 80
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
Finally, a perfectly meshing printed helical gear shaft for the Bambu P1/P1P extruder stepper motor — reverse-engineered, tested, and proven.
After extensive measurement, iteration, and real-world testing, this design solves the notorious “90° jam” issue that plagues generic 50T gears. It now runs smoothly, silently, and reliably with the stock Bambu 9T steel pinion — no binding, no skipping, full 360° rotation.
Key Features:
Precision Matched: Based on actual measurement of the Bambu P1P pinion (14 tooth flanks over 30 mm → 17° helix angle, not 15°!)
Integrated Gear+Shaft: Single-piece design (no slip, no press-fit failure)
Optimized Geometry:
Module: 0.5
Teeth: 50
Helix Angle: 17° Right-Handed
Pressure Angle: 20°
Backlash: 0.20 mm (ideal for PET-CF/PLA vs. steel pinion)
Face Width: 5.0 mm
Shaft: 5.0 mm diameter, 12 mm length + 1.5 mm shoulder for axial stability
Dual-Drive Ready: Designed to replace the stock 26mm spur gear in Voron dual-drive extruders (e.g., VORON 2.4, Trinamic-based builds)
Tested & Verified: Works flawlessly with Bambu P1P extruder stepper (model: BJY36D12-04V47)
🖨 Printing Recommendations:
Material: PET-CF (best), Nylon, or tough PLA (avoid standard PLA under high torque)
Nozzle: 0.4 mm (0.5 mm also works)
Layer Height: 0.08–0.10 mm for smooth tooth surfaces
Infill: 100% (gyroid or cubic)
Walls: 6–8 shells
Post-Process: Light sanding (400+ grit) on tooth flanks improves meshing
Mounting: Center distance = 15.4 mm (critical for 9T+50T, 17° helix)
The stock white plastic gear wears quickly and slips under load. This reinforced helical gear shaft delivers:
Higher torque transmission
Reduced noise & vibration
Longer lifespan
Seamless integration with Bambu hardware (no modding needed)
Perfect for Voron builders, DIY extruder upgraders, and anyone wanting reliable, quiet filament drive.