1 / 2
DJI RS 3 Pro Battery USB-C Port Dust Cover (TPU) — zdjęcie 1
1 / 2

DJI RS 3 Pro Battery USB-C Port Dust Cover (TPU)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A small TPU dust cover replacement for USB-C port recess on the DJI RS 3 Pro battery grip.

Ocena
0 / 5
Polubienia
1
Pobrania
8
Wydruki
0
Wyświetlenia
42
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial

Disclaimer (Important)

Not tested on a real DJI RS 3 Pro battery yet. Fit can vary between printers, TPU brands/hardness, slicer settings, and even manufacturing tolerances of the gimbal/battery. Print and test. Please let me know how it went - I'll gladly make some adjustments.

Recommended Material

  • TPU (recommended): best for a snug friction fit and easy insertion/removal.

  • PLA/PETG are not recommended for a press-fit dust cover here (risk of being too tight/too rigid).

Print Settings (Bambu A1 mini / general TPU-friendly)

  • Layer height: 0.20 mm

  • Perimeters/Walls: 4

  • Top/Bottom layers: 5 / 5

  • Infill: 100% (most consistent fit and grip)

  • Supports: Off

  • Brim: 3–5 mm (helps stability with TPU)

  • Speed (guideline): outer wall ~20 mm/s, inner ~30 mm/s, infill ~35 mm/s

  • Retraction: 0.6–0.8 mm @ ~20 mm/s

  • Temperature: use your filament profile (typical TPU is ~220–235°C nozzle, ~30–45°C bed)

Orientation

  • Place the part flat on its back (largest flat face on the bed), with the plug section pointing up. Use “Place on face / Drop to bed” in your slicer.

Fit Tuning Tips

  • If it’s too tight: reduce Flow by 1–2% or slightly increase temperature (+5°C).

  • If it’s too loose: increase Flow by 1–2%.

  • Don’t force it—this area is close to the USB-C connector.

Notes

  • The design includes a small friction feature (“lip”) to help it stay in place with TPU.

  • Please share your printer + TPU brand/hardness and fit results in the comments—feedback will help improve the model.

Changelog

  • v0.9 – initial release + community test prints (Makes)

Tagi