Stackable 5" (125mm) Sanding Disk Organizer

3-drawer storage unit to hold 5" (125mm) sanding disks. The drawers are removeable so you can take them to where you need them (the optional retention springs add tension and a soft stopping point when you pull the drawer nearly all the way out, but should not prevent removal). The units are able to be slotted together vertically and horizontally so you can customize your layout.

The design accommodates a pin system that helps align your sander to the disks so all you need to perfectly align your disks is set your sander dust collection ports on the pins and push the disks up through the hole in the center of the drawer bottom to make the hook and loop touch. The pins lock into the grooves of the drawer with a 90-degree, clockwise twist, and both 5 and 8-hole sanding disks should be compatible. The pins can be stored in the front-left corner of the drawer if using disks without dust extraction holes.

Link to Reddit post of videos: https://www.reddit.com/r/functionalprint/s/bKv8gsD7ca

Available label plates for sandpaper grits are as follows: blank (label how you want), 60, 80, 120, 150, 180, 220, 320, 400, 600.

There are screw holes to wall mount, and also a mounting plate to hang underneath a bench, cabinet, etc. Since the depth of the unit would make it a little difficult to mark the holes, I made a screw hole template that is also able to be dovetailed together so you can mark all of your screw holes easily and accurately. NOTE: The hanging plate and locking pins have not been tested as of posting.