1 / 5
Core One/+ Cable Cover Magnetic for 20 x 6 x 2mm magents — zdjęcie 1
1 / 5

Core One/+ Cable Cover Magnetic for 20 x 6 x 2mm magents

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of Core One/+ Cable Cover Magnetic by https://www.printables.com/@3Dprintfun for 20 x 6 x 2mm magents

Ocena
0 / 5
Polubienia
3
Pobrania
9
Wydruki
0
Wyświetlenia
158
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Core One heatbed cable cover remix based on the 3Dprintfun model.

I modified the original 3Dprintfun Fusion 360 design to use 20 × 6 × 2 mm magnets, that I had available at the time.

Two versions are provided: one for 2 magnets and one for 4 magnets. I found that 2 magnets are sufficient for general use, although the fit is not quite as secure as some may like. If you move your printer around frequently, you may prefer the 4-magnet version to reduce the risk of it becoming dislodged. For my setup, 2 magnets have proven to be secure enough.

Many thanks to 3Dprintfun for the original model — hope you find this remix useful.

In PrusaSlicer, you’ll need to add a pause to install the magnets. For me, this was at:

2.6 mm for 2 magnets

4.6 mm for 4 magnets (stacked)

I found a single layer of magnets to be strong enough, but you can add the additional magnets if you want a stronger hold.

I’ve included my Fusion 360 files, which remove the original magnet holes and adjust the internal geometry for anyone wanting to make further revisions. These are based on the model provided by 3Dprintfun.

Printed in PETG using the same settings as the original version. I didn’t have any orange filament to hand, so black was my forced choice. I’ve since ordered orange and will be reprinting — the magnets are easy to harvest and reuse.

Pruslicer setting:

Layer Height:

0.2mm Structural

Support:

Optional

Infill:

15%

Brim:

No

Material:

PETG

Filament

Black / Orange

2 Magnets:

Pause @2.6mm

4 Magnets:

Pause @ 4.6mm

Tagi