RAK / Sparkfun LoRa Antenna Wall / Window Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a window or wall mount for the RAK and Sparkfun LoRa antennas, tested with the 90cm long 5.8dbi antennas that…
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 57
- Wydruki
- 1
- Wyświetlenia
- 496
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is a window or wall mount for the RAK and Sparkfun LoRa antennas, tested with the 90cm long 5.8dbi antennas that can be found here: https://www.sparkfun.com/products/15597 https://store.rakwireless.com/products/fiber-glass-antenna?variant=39705894715590
The design has both screw holes and space on the back to mount 3M Command strips depending on your preferred method of mounting. The hole in the bottom allows the N type connector to fit through while not allowing the antenna to pass. The screw holes will fit a 5mm screw shaft and up to a 9mm head size. This mount should also fit any antenna that has a similar base width of about 30mm diameter. If you have any other antennas that fit, let me know so I can add them into the description.
For a smaller version of this mount that has been tested to work with the 45cm long Nebra antenna, visit this page: https://www.thingiverse.com/thing:4931849
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.24mm
Infill:
30%
Filament: eSun PETG Black
Notes:
PETG or stronger recommended for extended use / for areas outside.
Category: Electronics