IKEA HEJNE (Gnorm) Kombizangen Haken/ Pliers Hook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Kombizangen Haken für das IKEA HEJNE Regal. Stabilier breiter Haken für verschiedene Zangen.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 50
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
🧰 HEJNE Tool Hook – Simple & Strong
Minimalistischer Werkzeughalter für das IKEA HEJNE Regal.
Einfach einstecken, fertig.
Dieser Hook wurde speziell dafür entwickelt, perfekt in die vorhandenen Löcher des HEJNE Regals zu passen – kein Schrauben, kein Bohren.
Ideal für Zangen, kleine Tools oder alles, was schnell griffbereit sein soll.
⚙ Features
🔩 No tools needed – einfach einstecken
🧱 Perfekter Fit für IKEA HEJNE
🖨 Schnell gedruckt
💪 Stabil & belastbar
🧼 Cleanes, minimalistisches Design
🖨 Print Settings (Empfohlen)
Material: PLA / PETG
Infill: 20–40 %
Layer Height: 0.2 mm
Supports: ❌ nicht nötig
Orientation: wie im STL vorgesehen
💡 Tipp
Falls der Sitz nicht perfekt passt:
Zu locker?
→ leicht größer skalieren (z. B. 101–102 %)Zu eng?
→ leicht kleiner skalieren (z. B. 98–99 %)
→ oder mit PLA drucken, falls du PETG verwendet hast (weniger flexibel)
📸 Make it yours
Wenn du das Teil druckst, zeig’s her!
Lad gerne ein Make hoch – würde mich mega freuen zu sehen, wie du es nutzt 🔥
ENGLISH:
🧰 HEJNE Tool Hook – Simple & Strong
Minimalist tool holder for the IKEA HEJNE shelf.
Just plug it in – done.
This hook is specifically designed to fit perfectly into the existing holes of the HEJNE shelf – no screws, no drilling required.
Perfect for pliers, small tools, or anything you want to keep within easy reach.
⚙ Features
🔩 No tools needed – just plug it in
🧱 Perfect fit for IKEA HEJNE
🖨 Quick and easy to print
💪 Strong & durable
🧼 Clean, minimalist design
🖨 Print Settings (Recommended)
Material: PLA / PETG
Infill: 20–40 %
Layer Height: 0.2 mm
Supports: ❌ not required
Orientation: as provided in the STL
💡 Tip
If the fit isn’t perfect:
Too loose?
→ scale up slightly (e.g. 101–102%)Too tight?
→ scale down slightly (e.g. 98–99%)
→ or try printing with PLA if you used PETG (less flexible)
📸 Make it yours
If you print it, show it off!
Feel free to upload a Make – I’d love to see how you use it 🔥