IKEA HEJNE (Gnorm) Kombizangen Haken/ Pliers Hook
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Kombizangen Haken für das IKEA HEJNE Regal. Stabilier breiter Haken für verschiedene Zangen.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 11
- Makes
- 0
- Views
- 50
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
🧰 HEJNE Tool Hook – Simple & Strong
Minimalistischer Werkzeughalter für das IKEA HEJNE Regal.
Einfach einstecken, fertig.
Dieser Hook wurde speziell dafür entwickelt, perfekt in die vorhandenen Löcher des HEJNE Regals zu passen – kein Schrauben, kein Bohren.
Ideal für Zangen, kleine Tools oder alles, was schnell griffbereit sein soll.
⚙ Features
🔩 No tools needed – einfach einstecken
🧱 Perfekter Fit für IKEA HEJNE
🖨 Schnell gedruckt
💪 Stabil & belastbar
🧼 Cleanes, minimalistisches Design
🖨 Print Settings (Empfohlen)
Material: PLA / PETG
Infill: 20–40 %
Layer Height: 0.2 mm
Supports: ❌ nicht nötig
Orientation: wie im STL vorgesehen
💡 Tipp
Falls der Sitz nicht perfekt passt:
Zu locker?
→ leicht größer skalieren (z. B. 101–102 %)Zu eng?
→ leicht kleiner skalieren (z. B. 98–99 %)
→ oder mit PLA drucken, falls du PETG verwendet hast (weniger flexibel)
📸 Make it yours
Wenn du das Teil druckst, zeig’s her!
Lad gerne ein Make hoch – würde mich mega freuen zu sehen, wie du es nutzt 🔥
ENGLISH:
🧰 HEJNE Tool Hook – Simple & Strong
Minimalist tool holder for the IKEA HEJNE shelf.
Just plug it in – done.
This hook is specifically designed to fit perfectly into the existing holes of the HEJNE shelf – no screws, no drilling required.
Perfect for pliers, small tools, or anything you want to keep within easy reach.
⚙ Features
🔩 No tools needed – just plug it in
🧱 Perfect fit for IKEA HEJNE
🖨 Quick and easy to print
💪 Strong & durable
🧼 Clean, minimalist design
🖨 Print Settings (Recommended)
Material: PLA / PETG
Infill: 20–40 %
Layer Height: 0.2 mm
Supports: ❌ not required
Orientation: as provided in the STL
💡 Tip
If the fit isn’t perfect:
Too loose?
→ scale up slightly (e.g. 101–102%)Too tight?
→ scale down slightly (e.g. 98–99%)
→ or try printing with PLA if you used PETG (less flexible)
📸 Make it yours
If you print it, show it off!
Feel free to upload a Make – I’d love to see how you use it 🔥