1 / 11
PRUSA Core One+ swingarm flex extension
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
PRUSA Core One+ swingarm flex extension, to prevent sagging cable and PTFE hose
- Ocena
- 4,6 / 5
- Polubienia
- 33
- Pobrania
- 102
- Wydruki
- 4
- Wyświetlenia
- 693
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 4) (Komentarze: 21)Remiksy (1)Kolekcje (57)Powiązane
UPDATE: Improved opening for the M4 PTFE tube. Less pressure on the tube, and easier insertion for the PTFE tube and the cable.
Printed with PETG, without supports, layer height 0.2 mm in balance mode.
For assembly: The "swingarm flex extension" is slid onto the steel swingarm. It may require some force; if it doesn't slide all the way in immediately, pull it in and out several times until the end of the swingarm is visible at the opening in the "swingarm flex extension."
The cable and PTFE tube are simply clipped in. To assemble, pull the printhead all the way forward to the left corner and pull the swingarm with the flex extension towards the printhead so that it is still slightly bent.
The end should be approximately 7 cm from the cable exit on the printhead. Then, with a slight twist, press the cable sleeve into the rear clips on the printhead until it reaches the rear corner. Press the PTFE tube into the first clip without tension, starting in the same order as the cable sleeve.
In the parked position at the back right, the cable should be approximately 10-11 cm long from the end of the "swingarm flex extension" to the printhead outlet, and the PTFE tube should curve slightly downwards towards the "swingarm flex extension".
I would be very grateful for any feedback or suggestions.
Version history:
New M3 and the lid_M3 Version is much easier to mount. I add a small window that is posible to see that the swingarm is all in.
New M2: Would be more easy to slide into the steel swingarm.
New lid version : tube guide for the upper lid opening