Self-Draining Sponge & Soap Holder | Aerated
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A highly functional sponge/soap tray. Features elevated pegs for airflow and a sloped base to automatically drain water.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 96
- Wydruki
- 0
- Wyświetlenia
- 278
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
BOM: Printed with ROSA3D Starter PLA Black
Keep your sink area clean and extend the life of your sponges with this cleverly designed, self-draining holder. No more soggy, smelly sponges sitting in a puddle of water!
Key Features:
Elevated Peg Design: The sponge rests on a grid of sturdy pegs (spikes) rather than a flat surface. This ensures maximum airflow underneath the sponge, allowing it to dry incredibly fast and preventing mold or mildew build-up.
Auto-Draining Base: The bottom tray is specially profiled with a gentle slope. Any water that drips off the sponge automatically channels down and flows directly back into your sink.
Versatile: Perfect for standard kitchen sponges, steel wool pads, or even as a draining soap dish for the bathroom.
Easy to Clean: The open peg design makes it very easy to rinse out any soap scum under the tap.
Printing Instructions:
Orientation: Print normally (flat on the bottom).
Supports: NONE. The design is fully optimized to print without any support material.
Material: PETG or ABS/ASA are highly recommended. These materials have great water resistance and can withstand warm/hot water splashes from the sink much better than PLA.
Infill: 15-20% is plenty. Ensure you have at least 3 perimeters (walls) to make the pegs nice and strong.