1 / 2
Rotating Desk Edge Cable Clip / Otočný držák kabelů na hranu stolu — zdjęcie 1
1 / 2

Rotating Desk Edge Cable Clip / Otočný držák kabelů na hranu stolu

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

EN Rotating desk edge clip for 1–2 cables. CZ Otočný držák na hranu stolu pro 1–2 kabely.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
34
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial

Rotating Desk Edge Cable Clip

Print-in-place rotating cable holder for the edge of a desk or table.

The clip slides onto a tabletop approximately 35–40 mm thick. The rotating holder can hold one or two cables with a diameter of about 6 mm.

Use

This holder is intended for simple cable management on a desk edge. It helps keep charging cables, USB cables, audio cables, or similar cables close to the table instead of falling behind or under the desk.

The cable holder part can rotate inside the clip, so the cable direction can adjust naturally.

Compatibility

  • Desk / tabletop thickness: approx. 35–40 mm

  • Cable diameter: approx. 6 mm

  • Holds 1 or 2 cables

  • Print-in-place rotating design

Recommended print settings

  • Material: PETG

  • 4 perimeters with a 0.4 mm nozzle

  • Printed mainly / fully with perimeters for flexibility

  • No supports

  • Print-in-place


Otočný držák kabelů na hranu stolu

Print-in-place otočný držák kabelů na hranu stolu nebo pracovní desky.

Klipsna se nasune na desku stolu o síle přibližně 35–40 mm. Otočná část držáku je určena pro jeden nebo dva kabely o průměru přibližně 6 mm.

Použití

Držák slouží pro jednoduché vedení kabelů na hraně stolu. Pomáhá udržet nabíjecí kabely, USB kabely, audio kabely nebo podobné kabely u pracovní desky, aby nepadaly za stůl nebo pod stůl.

Samotný držák kabelů je v klipsně otočný, takže se směr kabelu může přirozeně přizpůsobit.

Kompatibilita

  • Síla desky stolu: cca 35–40 mm

  • Průměr kabelu: cca 6 mm

  • Pro 1 nebo 2 kabely

  • Print-in-place otočný mechanismus

Doporučené nastavení tisku

  • Materiál: PETG

  • 4 perimetry při trysce 0,4 mm

  • Tištěno převážně / čistě perimetry kvůli pružnosti

  • Bez podpor

  • Print-in-place

Tagi