Rotating Desk Edge Cable Clip / Otočný držák kabelů na hranu stolu
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
EN Rotating desk edge clip for 1–2 cables. CZ Otočný držák na hranu stolu pro 1–2 kabely.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 31
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
Rotating Desk Edge Cable Clip
Print-in-place rotating cable holder for the edge of a desk or table.
The clip slides onto a tabletop approximately 35–40 mm thick. The rotating holder can hold one or two cables with a diameter of about 6 mm.
Use
This holder is intended for simple cable management on a desk edge. It helps keep charging cables, USB cables, audio cables, or similar cables close to the table instead of falling behind or under the desk.
The cable holder part can rotate inside the clip, so the cable direction can adjust naturally.
Compatibility
Desk / tabletop thickness: approx. 35–40 mm
Cable diameter: approx. 6 mm
Holds 1 or 2 cables
Print-in-place rotating design
Recommended print settings
Material: PETG
4 perimeters with a 0.4 mm nozzle
Printed mainly / fully with perimeters for flexibility
No supports
Print-in-place
Otočný držák kabelů na hranu stolu
Print-in-place otočný držák kabelů na hranu stolu nebo pracovní desky.
Klipsna se nasune na desku stolu o síle přibližně 35–40 mm. Otočná část držáku je určena pro jeden nebo dva kabely o průměru přibližně 6 mm.
Použití
Držák slouží pro jednoduché vedení kabelů na hraně stolu. Pomáhá udržet nabíjecí kabely, USB kabely, audio kabely nebo podobné kabely u pracovní desky, aby nepadaly za stůl nebo pod stůl.
Samotný držák kabelů je v klipsně otočný, takže se směr kabelu může přirozeně přizpůsobit.
Kompatibilita
Síla desky stolu: cca 35–40 mm
Průměr kabelu: cca 6 mm
Pro 1 nebo 2 kabely
Print-in-place otočný mechanismus
Doporučené nastavení tisku
Materiál: PETG
4 perimetry při trysce 0,4 mm
Tištěno převážně / čistě perimetry kvůli pružnosti
Bez podpor
Print-in-place