RX9070 GPU Brace for S300 and Universal ITX Cases
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adjustable GPU brace for S300 and other ITX cases, designed to support a Gigabyte RX9070 during transport.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 122
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple parameterized GPU brace designed to support the end of a graphics card and reduce movement during transport or daily use.
I originally designed this for my S300 ITX build with a Gigabyte RX9070, but the model is parameterized, so it can be adjusted for other cases and GPU clearance setups. You can download the f3d file I have included to customize it to your case.
The brace uses three main parameters:
GPU distance to front panel
Foam thickness
Compression thickness
In my build, the gap between the GPU and the case front panel was 16 mm. I used 3 mm foam with around 1 mm of compression so the brace gently supports the GPU without pushing too hard against it.
The shape follows the chamfered lines of the GPU shroud, so it looks more integrated instead of just being a plain block inside the case.
Recommended use:
Measure the distance between your GPU and the case panel, then adjust the parameters before printing. Add a thin foam pad between the brace and the GPU to avoid direct hard contact.
Print notes:
I printed mine in ABS. PETG should also work. PLA may be fine for cooler builds, but I would avoid it if the brace sits close to a hot GPU or inside a high-temperature SFF case.