Additional Carbon Holder for Flashforge AD5X / AD5M Filter Ducts

I don't charge for my functional models. Please consider purchasing some of my paid models as a way to support both my work, and this great website: https://www.printables.com/@ninjamida/store

Check out my other AD5X replacement parts, mods and upgrades (all free!).

Holders for carbon pellets for your Flashforge Adventurer 5M [Pro] or AD5X. Can be printed in under an hour (per unit) when using a 0.6mm nozzle.

- Do not print in PLA. The recommended material is ABS, but PETG should be okay.
- Supports are NOT needed.
- Either 0.4mm or 0.6mm nozzle can be used.
- Slightly thin layers recommended (0.16mm for a .4 nozzle or 0.24mm for a .6) for layer bond strength.
- Print the main piece on its large flat side, and the cap upside down (ie: with the two semicircular indents facing towards the bed).

Fill with carbon pellets through the top hole, insert and twist the cap to close it, then replace your existing filter cover with this.

Based on readings from an SGP30 sensor while printing ABS and running the recirculation at 25% with a (slightly old) Juupine filter, this cut VOC levels by about 35%.

IMPORTANT: In stock configuration, only the Adventurer 5M Pro is equipped with the necessary ducts and fans to make use of any kind of filtration via these slots - whether it's this model, off-the-shelf filters, or any other filter. If you have a standard Adventurer 5M or an AD5X, these will only be useful if you have added recirculation and exhaust ducting and fans to your printer. Which in turn, are only really useful if you have an enclosure.