CPU fan mount CWWK NAS mainboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bracket to upgrade cooling with an 80 or 92mm fan for CWWK/Topton NAS mainboards
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 91
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to upgrade the existing CPU cooler for my CWWK 8-bay NAS i5-8265U (https://cwwk.net/products/changwang-cwwk-micro-control-8-bay-nas-intel-i5-8265ues-with-8-sata-dual-m-2-dual-channel-ddr4?variant=47663280423144). The CPU fan that came with the board did not allow me to have the fan stop at 0% duty cycle PWM, and the minimum fan speed was too loud for my taste, so I changed it to a 92mm Noctua fan that is very quiet and supports 0 RPM.
The bracket mounts to the existing 3 screw holes (35mm spacing) on the heat sink and has holes to attach an 80mm or 92mm fan. This bracket should also work for other mainboards from CWWK and Topton that use the same CPU cooler (e.g. NAS-N150-6P, NAS-N150-8P). The mounting holes for the fan are meant for M3 threaded inserts, but they also work for the common fan screws that bite into the plastic. The total height of the stack, measured from the surface of the mainboard to the top of the 25mm thick fan is 47mm.
I printed it in PETG, if you want to have more of a margin regarding temperature resistance, maybe use ASA, or annealed PLA.