1 / 1
Dual Mean Well UHP-200 DIN mount with 40mm fans — zdjęcie 1

Dual Mean Well UHP-200 DIN mount with 40mm fans

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount for the Mean Well UHP-200 series power supplies, with 40mm fan and optional JST breakout for clean wiring

Ocena
0 / 5
Polubienia
4
Pobrania
8
Wydruki
0
Wyświetlenia
67
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
BSD License

Mount for 2x Mean Well UHP-200 series power supply, including space for 40mm fans (4010, 4015, 4020).

Required hardware:
- 24x M3x4x5 heat insert
- 12x M3x8mm SHCS for mounting the power supply and mounting the DIN rail adapter
- 8x M3x18mm BHCS for mounting the fans (with inserts)
- 8x M3x25mm BHCS for mounting the fans (if mounting with nuts)
- 4x M3x6mm FHCS for mounting the lid
- 4x M3 hex nut for mounting the lid
- 3x JST XH 2p terminal
- some wiring (22 AWG)
- soldering iron

Preparation:
- Prepare a JST XH 2p terminal, add 2 wires to each leg (e.g. a 40mm and 50mm wire)
- Insert the JST XH 2p on the front, make sure to thread on wire from each leg trough the back holes
- Solder the wire ends each to a JST XH 2p
- Insert the JST XH 2p terminals into the holes while feeding back the wire into the internal cavity
- Secure with a dab of CA glue

Setup:
- Press the heat inserts into both sides
- Insert the lid nuts inside the sides
- (optionally) press the heat inserts into the fan screw mounts, or secure with nuts
- Mount the fan
- Mount the power supplies
- Mount the lid
- Mount the DIN bracket clips

Using the DIN rail clips from the "DIN rail bracket redux" project, inspired by DoubleT's Dual UHP mount, but otherwise original work.

Tagi