1 / 3
Dust port adapter WEN JT630H 6" Jointer to 4" Duct — zdjęcie 1
1 / 3

Dust port adapter WEN JT630H 6" Jointer to 4" Duct

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dust port adapter for the WEN JT630H 10-Amp 6-Inch Spiral Jointer. Replaces the undersized OEM 2-1/2" dust chute with 4"

Ocena
0 / 5
Polubienia
0
Pobrania
8
Wydruki
0
Wyświetlenia
30
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
GNU General Public License v3.0

Summary

Custom dust port adapter for the WEN JT630H 10-Amp 6-Inch Spiral Benchtop Jointer. Replaces the undersized OEM 2-1/2" dust chute with a proper 4" connection for your dust collection system. Single-piece design — no glue, no assembly.

The Problem

The WEN JT630H comes with a tiny 2-1/2" dust port that constantly clogs and provides inadequate chip evacuation. This adapter replaces the OEM chute entirely and transitions to a standard 4" (95mm ID) round duct connection, dramatically improving airflow and chip collection.

Design Details

Single-piece construction — prints as one part, no assembly required

Direct bolt-on mounting — uses the existing jointer mounting bolts via 4 open-ended slots (slide on/off without fully removing bolts)

Flange plate: 185 × 98 × 4mm with 149 × 62mm rectangular opening

Smooth rectangle-to-round transition: 50mm loft from rectangular opening to circular exit

Round exit: 95mm ID / 101mm OD — standard 4" flexible duct slides directly inside

Mounting slots: 9.6mm deep × 7mm wide, positioned 5mm from the long edges

Dimensions

FeatureMeasurement

Flange plate185 × 98 × 4mm

Opening149 × 62mm

Round exit ID95mm (4" duct inserts here)

Round exit OD101mm

Transition height50mm

Round stub length25mm

Total height79mm

Print Settings

Material: PETG recommended (workshop durability, vibration resistance)

Layer Height: 0.2mm

Infill: 25-30%

Walls: 3-4 perimeters

Supports: None needed (print with flange flat on bed)

Orientation: Flange plate down on build plate

Bed size required: 185 × 101mm minimum

Installation

Loosen (don't remove) the 4 mounting bolts on the jointer's dust chute area

Slide the adapter's open-ended slots over the bolts

Tighten bolts to secure

Insert your 4" flexible dust collection hose into the round stub

Optionally seal with a hose clamp for a tighter fit

Compatibility

WEN JT630H (confirmed fit)

May fit other WEN 6" benchtop jointers with the same chute dimensions

Round exit accepts any standard 4" (100mm) flexible dust collection hose

Files

.scad — Parametric OpenSCAD source file (all dimensions adjustable)

.stl — Ready-to-print mesh

Customization

The OpenSCAD source file is fully parametric. You can adjust:

round_id — change if your duct is a different size

flange_border — adjust mounting flange width

transition_height — make the transition longer/shorter

slot_depth / slot_width — adjust for different bolt configurations

Tagi