1 / 1
90mm PC Fan to 3 Inch HVAC Duct Adapter — zdjęcie 1

90mm PC Fan to 3 Inch HVAC Duct Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Created this to vent out the enclosure that I made for my Ender 3.

Ocena
0 / 5
Polubienia
2
Pobrania
22
Wydruki
0
Wyświetlenia
68
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I have included 2 models. 1 made to fit my pc fans' outline/silloete and 1 universal one. I recommend that you print one of each. The extra universal one can be used to make a flush window mount if you just cut some plexiglass or foam as I did.

MATERIALS:

  1. PLA

  2. (4) 6 mm magnets.

  3. 3-inch dia HVAC duct (preferably aluminum, but PVC also works as the temperatures are not that hot.)

  4. 12V power supply that you probably have lying around, such as in an old charger.

  5. arduino jumber/dupont cables 

  6. 6 mm drill bit

  7. Hot Glue

  8. SuperGlue

I created this as I wanted to vent the air inside the Ender 3 enclosure that I created. The temperature inside the enclosure was getting too hot and the PLA filament was undergoing its glass transition by the time it reached the hot extruder motor, jamming it. This solved that issue and cleared the annoying fumes from printing safely outside. 

INSTALLATION:

Fan Prep:

  1. Drill out the screw holes on your pc fan with a 6mm drill.

  2. Place the 6mm magnets inside the hole. Use heat if necessary to get them to fit.

  3. Secure with Super Glue.

  4. Plug the jumper cable into the PC fan positive and negative slots. Ignore the third signal slot. That can remain empty.

  5. Insert the 12V power supply into the wall. If you have one with a barrel connector, the positive is usually on the inside. Place the positive lead inside. Place the negative lead on the outside. The fan should spool up if the voltage and polarity is correct. If not, just reverse the polarity. Secure the leads in the barrel connector with hot glue. Don't worry; the fan is so low amperage (0.2A for most) and voltage that hot glue is more than fine.

  6. Wrap around with electrical tape.

Model Prep:

  1. Place the model on the PC fan roughly in position.

  2. Place the magnets in one by one so that they snap in the right polarity.

  3. Secure magnets in place with SuperGlue.

  4. Slide/screw the duct into the adapter.

MAKE SURE THE POLARITY OF THE MAGNETS ON THE ADAPTER ARE ON THE SAME SIDE. MISMATCHING WILL RESULT IN THE ADAPTER POPPING OUT.

Tagi