CM4 4010 fan mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
4010 fan mount that fits the profile of a CM4, CB1, CB2 style board for cooling of the board. Perfect for manta boards.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 40
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
BOM:
4010 axial fan
4 x M3x12 bolts
4 x M2.5 bolts. This adds 2mm onto the threads of the current mounting bolts. Unless your bolts are sized perfectly, you can probably reuse them as the extra 2mm will still give enough tread engagement. My 8mm bolts that I had installed were plenty long enough.
optional - 1 zip tie for cable management. Smaller the better.
Print settings:
STL is orientated correctly
Voron standard
Installation:
Place the 4010 fan into the bottom recess. Note there is a zip tie point in one corner, if you intend to use this for the wires then ensure the fan is orientated appropriately.
Thread the 4 M3x12 bolts through the fan and into the mount. It is deliberately a tight fit for the bolts are you are threading into the plastic. Take your time and be careful not to strip any.
Tie down the cable if desired, using the provided channel. This can be tight with thicker zip ties.
Remove the 4 M2.5 screws holding the board in place and place the fan on top. Reinstall the bolts securing everything in place.
Update your printer.cfg as appropriate. This has been my go to settings.