RAK WisMesh 1W Booster Starter Kit case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Houses the PCB, antennas, and 2x18650 batteries
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 361
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a case for the rak wismesh 1w booster kit. It houses the RAK3401, RAK13302, and RAK19007 boards. It has spots for a GPS antenna for an optional RAK12501. It has spots to put the BLE and the LORA antennas that come with the kit. It houses two 18650 batteries in the back, wired in parallel.
Some minimal supports are recommended for things like the battery box and the PCB box, and the battery door. The battery box should be printed on its back, with the slots for the 18650s facing up.
Parts needed:
WisMesh 1W Booster Starter Kit
8x M3x6 hex button head screws
4x Keystone #209 battery contacts
some wire for hooking up batteries
JST-PHR2 connector for connecting the batteries to the BATT connector on the board (verify the battery pack polarity. There is a + indicator on the board indicating which pin is the positive for the battery connector)
Assembly
All holes are meant to self thread with the appropriate screw.
Assemble the battery pack separately for ease of access. Solder the keystone 209 contacts so they have the batteries in a parallel configuration. There are holes to feed the wires through.
Screw the battery box into the PCB box from the side of the PCB box with 4 m3x6 screws.
Screw the PCB into the PCB box with the screws that come with it. Attach the antennas and put them into their slots. Attach the external antenna.
The lid is secured with 4x m3x6 screws.