45° Ruler Holder — Multibin Insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Multibin insert that stores rulers at a 45° angle, letting them extend up and over the top edge of your Multiboard for
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
This is a Multibin insert for storing rulers at a 45° angle, using the empty space above a Multiboard that would otherwise go unused.
It's a single block — print two, orient them differently, and use them as a pair:
The endstop sits lower and stops the rulers sliding down and off.
The support sits one LU higher and holds the rulers up, stopping them from tipping over.
Mount the endstop low and the support one LU higher — for example using bolt-locked shelves angled at 45° — and a ruler bridges between the two, extending up past the top edge of your Multiboard instead of taking up space on it.
Each block holds up to 5 rulers side by side. Any width or length works — the dividers just space them out.
Mount with a Micro Shell and Insert Pins, whether you're using shelving or attaching straight to your Multiboard wall.
Inspired by this ruler holder, which stores rulers flat. I wanted something that would let rulers extend past the board edge instead, to save space.
Editable source
Model available on Onshape if you want to modify it.
Print settings
Standard Multibuild printing guidelines apply, but honestly any settings will print this fine.
Credit
Designed to fit the Multibuild system.