Cable Wall Plug
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A custom plug allowing a cable to pass through. Designed for Ø.3 inch cable and a Ø.75 in hole in 1/2" drywall.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 125
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
A custom plug allowing a cable to pass through. Designed for Ø.3 inch cable and a Ø.75 in hole in 1/2" drywall.
Print two pieces and press-fit them together before pushing or pounding it into the wall. The plug can be assembled after the cable has passed through the wall hole.
I designed this for a 3/4" diameter hole because I could not find a similar model elsewhere, and because I wanted there to be little-to-no gaps that could let bugs through. When printed in PETG, it did the job perfectly and was tough enough to be hammered into place.
Recommended Print Settings:
0.2mm layer height
No brim
Grid infill, 15% (10% gyroid should also work)
No supports needed
Print with the large, flat face on the build plate. The press-fit pins need to be horizontal to maximize shear strength.