Ford Steering Wheel to 6x70 Racing Wheel Mount Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For a better sim trucking experience.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 66
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
I had a steering wheel from a 3rd generation Ford Expedition laying around, and one thing led to another, and the result was me making this model. This will work for similar Ford/Linclon steering wheels found on the F150 and Superduty trucks from the late 00's and early 10's, and potentially steering wheels from other Ford models in the same era.
Heres a video on how to remove the steering wheel from 12th gen (2009-2014) F150
Heres a video on how to remove the steering wheel from the 2nd gen (2008-12) Superduty, also applies to 3rd gen Expedition.
The mounting holes to the controller are made for M5 screws and are 9.1mm from the bottom of the head of the screw to the bottom face of the adapter. The total screw length will vary based on your setup.
Hardware
2 - M8x40 Bolts
2 - M8 Washers
2 - M8 nuts
The Steering Wheel
(Optional) The original torx screw reused from the car for mounting the steering wheel to the steering column
Print tips
Lots of walls, but you don't need a lot of infill; you'll want to keep the weight low. I used 11 walls on a .4mm nozzle. I also recommend turning on "One wall on first layer" and "One wall on top surfaces" as this makes it so that the bolts will be essentially sandwiching the thick wall columns between the two top surfaces and prevents the column from popping out of the part when you torque the screws.
Assembly
Using one of the M8 Bolts, press the nuts into their respective slots to the bottom.

Mount the adapter to the controller and torque down. The screws are designed to go in towards the controller. Route any cables through the top square hole and down the channel before putting on.

Screw and torque down the Torx bolt onto the center hole. This is mainly to get it flush against the mount for the two M8 bolts, so it's not required if you don't have it, but I recommend putting it in for those that do for added security.

Put the washers on the M8 Bolts then screw and torque down into the two holes next to the center hole.

Click the airbag module/horn button back into the steering wheel. I recommend removing the actual airbag and inflator, as they are both heavy and this wheel is significantly heavier than any sim racing wheel already. You will have to re-attach the positive wire of the horn button somehow, as it's riveted onto the airbag module; an alligator clip may be all you need.

Enjoy your upgraded sim racing setup.
