Floating Corner Shelf for Toilet Brush / Bathroom Organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalist Corner Floating Shelf for Toilet Brush / Bathroom Organizer
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 35
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Minimalist Corner Floating Shelf for Toilet Brush / Bathroom Organizer
A clean, floating corner shelf designed to keep your toilet brush holder, soap dispenser, or bathroom essentials off the floor for effortless mopping and a tidy look.
Featuring a round platform with a raised rim and an angled corner backplate, it slots precisely into 90° tiled wall corners without wobbling.
Key Features
Cleaner Bathroom Floors: Elevates the brush canister off the floor, making floor cleaning and mopping quick and hassle-free.
Spill & Slide Protection: Raised outer lip/rim keeps the container safely centered and prevents it from slipping off.
Damage-Free Mounting: No drilling required! Designed with flat contact wings on the backplate for double-sided tape.
Silicone Joint Clearance: Angled rear corner accommodates standard bathroom silicone beads and grout lines smoothly.
Platform Size: Comfortably fits round brush holders and bottles up to ~138 mm (14 cm) base diameter.
⚠ Important: Mounting & Tape Recommendation
Because this shelf holds weight cantilevered in a humid bathroom environment, the quality of your double-sided tape is crucial:
Use Heavy-Duty Tape: Do not use cheap foam tapes or standard poster strips. We strongly recommend high-strength, waterproof tape such as 3M VHB, Tesa Powerbond (Waterproof/Bathroom), or heavy-duty acrylic nano tape.
Surface Prep: Clean and degrease both tile surfaces thoroughly with isopropyl alcohol (IPA) to remove dust, soap scum, or limescale.
Curing Time: Press firmly into the corner for at least 30–60 seconds, and let the adhesive cure for 24 hours before placing any weight on the shelf.
Print Settings
Parameter | Recommended Value |
Material: | PETG (preferred for humidity, cleaning agents, and long-term durability) |
Layer Height: | 0.20 mm (Standard) |
Walls / Perimeters: | 3 to 4 (critical for rigid cantilever load support) |
Infill: | 15–20% (Gyroid) |
Supports: | None (prints completely support-free flat on the bed) |
Brim: | Optional / Not needed on a clean textured PEI plate |
