1 / 6
Creality Hotend Heater Change Tool for K1 and Unicorn Nozzle series — zdjęcie 1
1 / 6

Creality Hotend Heater Change Tool for K1 and Unicorn Nozzle series

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A tool for removing the heater block top thread on Creality K1 and Unicorn-series hotends.

Ocena
0 / 5
Polubienia
0
Pobrania
2
Wydruki
0
Wyświetlenia
33
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

Creality K1 / Unicorn Hotend — Heater Block Removal Tool

The heater on Creality K1 and Unicorn-series hotends fails fairly often — either the heating element burns out or a wire breaks.

Typical symptoms:

The thermistor still works and reads room temperature (28–32 °C), but the hotend never heats up.

The printer may show error code 2564.

Check it with a multimeter. If you get an open circuit, the heater is dead — on my tester that shows as 1. on the display, but other meters show OL or ∞.

You don't need to buy a complete hotend assembly. Replacing only the ceramic heater block is enough, and it costs far less than a full unit that includes the thermistor and everything else.

The problem is that the upper threaded section is often very hard to loosen by hand — that's why I made this tool.

Watch the thread direction. It is a left-hand (reverse) thread: turn the upper part clockwise (to the right) to loosen it.

Suggested print settings:

6 walls, 6 top and bottom layers, 40% infill

Or 4 walls, 4 top and bottom layers, 35% infill, with a modifier on the head section only at 6 walls / 40% infill

Tagi