1 / 3
Jonsbo N series SSD Caddy - For N1, N2, N3, N4, N5, etc. — zdjęcie 1
1 / 3

Jonsbo N series SSD Caddy - For N1, N2, N3, N4, N5, etc.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A caddy for installing 7mm thick SSDs in Jonsbo N series cases. Fitment confirmed on N3 & N5, others presumed.

Ocena
5 / 5
Polubienia
21
Pobrania
57
Wydruki
1
Wyświetlenia
423
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Designed to allow installation of 2.5" SSDs in the 3.5" bays of Jonsbo N series case.

I tried another design that I got off Printables and it didn't fit, so I designed my own.

It has sprung clips that hold the SSD in place, and the top rail is sprung to create a snug fit when installed to minimize vibration.

Printed on a Prusa Core One in cheap PLA, 0.2mm layer height, 15% infill. About 50g and 3 hours to print.

Please note: When I was trying to get the previous model I downloaded to fit in my N3, I loosened the SATA backplane mounting screws and lifted the backplane as far up as the play on the mounting holes would allow (only a fraction of a millimeter). It didn't work with the old design, but this is how the backplane was left, so you may have to do the same for these to fit, just loosen the screws slightly, push the backplane up and re-tighten them. Or better yet, if you have 2 SSDs, print 2 caddies, loosen the screws then install a drive at either end of the enclosure, then re-tighten the screws.

Fitment has been confirmed on the N3 and N5, other Jonsbo N series cases use the same mounting system, so these should fit them as well, but haven't been tested. If anyone confirms fitment in any other cases, please let me know and I'll update the description.

Tagi