1 / 3
Pickleball Waistband Holder - snap-in cage for 1 or 2 balls — zdjęcie 1
1 / 3

Pickleball Waistband Holder - snap-in cage for 1 or 2 balls

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Waistband or belt clip with snap-in cages for one or two pickleballs, plus a ball size gauge.

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
19
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

A clip for your waistband or belt that holds one or two pickleballs. Each ball pushes into an open cage, and eight flexible petals close round it just above its middle, so it stays put while you move. To take a ball out, pull it up, or push it from underneath through the open bottom.

The cage is sized from the official ball rule (2.87 to 2.97 in, or 72.9 to 75.4 mm), so any approved ball fits with clearance once it has snapped in. The lip is 3 mm narrower than the design size, which gives the snap. The clip hooks over the waistband from above and has a grip ridge on the inner leg.

It prints standing up as one piece, with no supports. The cage overhangs are 30 degrees or less, and the only bridge is the 4 mm across the top of the clip.

Also included is a ball size gauge: drop a ball into the tapered jaw and read its diameter where it stops. If your balls are at the small or large end of the range, or your waistband is thicker than usual, change ball_d, grip or waist_gap in the OpenSCAD file. The STLs are the 1-ball and 2-ball holders.

Print settings:

  • 0.2 mm layers, 0.4 mm nozzle, 3 walls, 20% infill

  • No supports. Print as supplied: cage bottoms and both clip legs on the bed.

  • PETG recommended (it bends rather than cracks and copes with a hot court). PLA works but is stiffer and more brittle.

  • A brim helps keep the thin clip leg on the bed. Print the 1-ball holder first to check the snap.

I designed this in OpenSCAD with AI help.

If you print one, I'd love to see it. Post a make with a photo, good or bad, and it helps me improve the next version.

Also on Cults: https://cults3d.com/en/3d-model/various/pickleball-waistband-holder-snap-in-cage-for-1-or-2-balls-parametric

Tagi