Scooter / Bike Phone Stand Mount (M365)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Phone holder for bikes or scooters that with a straight handlebar.
- Ocena
- 5 / 5
- Polubienia
- 615
- Pobrania
- 2757
- Wydruki
- 12
- Wyświetlenia
- 15 197
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
STLs
All files are in correct Z orientation
- Main (Use one of the following) +main.stl (for ~22.5mm handlebar) +main-short.stl (shorter stem) +main-32mm.stl (for ~32mm handlebar)
*jaw.stl *screw.stl
- Clip (Use one of the following) +clip.stl (for ~22.5mm handlebar) +clip-with-loop.stl (use this if you want to hang a bag on your scooter that uses velcro loops, and you don't have any space left on the handlebar) +clip-32mm.stl (for ~32mm handlebar)
Screws & Nuts
*4x M4x20 *8x 10mm Washers *4x M4 Nuts *1x M4x50 (screw this inside the printed screw to strengthen it)
About the design
This is originally designed to fit Xiaomi M365 Pro scooter which has ~22.5mm diameter handlebar. But should fit on most bikes or scooters that have a straight handlebar. It needs 45mm of handlebar space. Phone sizes I've tries are from small iphone 5 to large "max" sized iphones.
If you need a custom size...
Comment if your handlebar is much bigger than 22.5mm, and i can give you updated STL. :)
My handlebar diameter is 22.5 mm, but it should fit few mm bigger handlebars as well. For smaller diameter, you can use rubber padding.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0,3 or less
Infill:
20% or higher
Notes:
No supports needed, and all files are in correct Z orientation. For extra strength increase Perimeters to 3 (or more) instead of infill (20% is enough).
Category: Mobile Phone