1 / 10
Gridfinity 2x3 Anker Prime 3-in-1 Charger Holder — zdjęcie 1
1 / 10

Gridfinity 2x3 Anker Prime 3-in-1 Charger Holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A 2x3 Gridfinity holder for the Anker Prime 3-in-1 foldable wireless charger, with a front gate and magnet slots.

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
18
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Standard Digital File License

A Gridfinity 2x3 holder that locks the Anker Prime Wireless Charging Station (3-in-1, MagGo, AirCool, Foldable) to your baseplate. The charger stops sliding around when you grab your phone, and it still folds open with the holder on.

Features

  • Standard 2x3 Gridfinity footprint with 24 magnet pockets (6x2 mm).

  • Floor grooves line up with the charger's rubber feet so it seats in the same spot every time.

  • Side rails and a back hook hold the charger down.

  • Removable front gate locks it in. Hook a finger through the slot to pull it out.

  • Cable hole in the back pocket.

What you need

  • 24 magnets, 6x2 mm (optional, for magnetic baseplates)

  • Super glue for the magnets

Printing

  • Material: PLA. Mine is printed in glow-in-the-dark PLA.

  • No supports. Both parts are on one plate in the 3MF.

  • Print the gate as placed (front face down).

Install

  1. Line the rubber feet up with the two floor grooves.

  2. Slide the charger in from the front, under the side rails and the back hook, until it stops.

  3. Press the gate's legs into the two front sockets.

Remove

Hook a finger through the gate's slot, pull it up, then slide the charger forward.

Built on the open Gridfinity system by Zack Freedman.

Print profile

Glow PLA, 0.2mm, 2 walls, 10% infill (Holder + Gate)

Both parts on one plate, X1 Carbon, 0.4 mm nozzle. Printed in glow-in-the-dark PLA.

  • 0.2 mm layers, 2 walls, 10% 3D honeycomb infill

  • No supports

  • The gate prints front face down as placed

  • Glue in 24 magnets (6x2 mm) after printing

  • Sliced for: Bambu Lab X1 Carbon

  • Plates: 1

  • Print time: about 1 h 29 min

  • Filament: PLA #FFF144 (42 g)

  • File: the 3MF labeled "print profile" in Model Files

Also on MakerWorld, with one-click print profiles for Bambu Studio: Gridfinity 2x3 Anker Prime 3-in-1 Charger Holder

Tagi