CORALBOARD SL-15
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
15 mm CoralBoard case with a 30 mm fan top or a vented top.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 167
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
CoralBoard SL-15
A clean, ultra-low-profile enclosure for the Synaptics CoralBoard SL. The 15 mm design protects the board while keeping its connectors accessible.
Configurations
Fan configuration: a top designed for a 30 mm fan, with snap-in TPU feet.
Vented magnetic configuration: a passive vented top, with TPU adapters for 6 × 3 mm magnets.
The magnetic adapters let you attach the enclosure to a suitable ferromagnetic surface, such as the underside of a steel desk. This keeps the CoralBoard tucked out of sight and frees up desk space. Magnets do not attach reliably to every metal, so check that the mounting surface is magnetic.
Fan power and control
The board provides a 3.3 V supply for the fan connection. A standard 5 V fan needs either a suitable boost converter powered from 3.3 V, or a properly wired connection to the 5 V USB-C input supply. Check that the power source can handle the fan’s current as well as the board’s load.
Alternatively, use a fan rated to operate at 3.3 V. A fan connected directly to a fixed supply will run continuously. Software speed control may be possible with a compatible fan, a suitable driver circuit and a software-controllable output supported by your board setup. Do not power the fan directly from a GPIO pin.
Hardware
4 × M2.5 heat-set inserts
4 × M2.5 screws
Optional 30 mm fan for the fan configuration
Optional 6 × 3 mm magnets for the TPU magnet adapters
Assembly
Install the heat-set inserts and buttons in the case.
Place the CoralBoard in the case base, aligning it with the mounting features and keeping the connectors clear.
Choose the top configuration: fan top or vented top.
For the fan configuration, mount the 30 mm fan to the fan top.
Close the case and secure the layers with the M2.5 screws, engaging them with the heat-set inserts.
Press the TPU feet into their underside seats. The feet snap into place and cover the screw heads for a clean exterior.
For the magnetic configuration, fit the 6 × 3 mm magnets into the TPU adapters.
