OBS Ford Taillight Bulb Hole Plug - 9007 / HB5 Twist-Lock Cap (1992-1997 F-Series & Bronco)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Twist-lock plug for the 9007/HB5 bulb hole on OBS Ford headlights. Keeps dust and bugs out during storage or cleaning.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 19
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Plugs the bulb opening in the back of the OBS Ford composite headlight housing while the bulb is out. Use it to keep dust, moisture and bugs out during storage, or to seal the housing while you clean or restore it.
It twists in like the factory 9007 bulb: line up the 3 keyed tabs, push it in, and turn it to lock. Turn it with the slot on the face, using a flat screwdriver or a coin.
FITS
The 9007 / HB5 (PX29t) twist-lock bulb opening. Tested on a 1997 F-250. It should fit other headlight housings that take 9007 bulbs, but test-fit first. 1987-1991 trucks use 9004 bulbs and are not tested.
SIZE
43 mm cap. The twist-lock body is 29.3 mm, 31.3 mm across the tabs, and 5.4 mm deep.
PRINT SETTINGS
PETG recommended. I used Sunlu PETG HS at 0.12 mm layers, 3 walls and 15% gyroid infill. Print it face-down (flange flat on the bed), with small tree supports only under the inner ledge. It takes about 18 minutes. Print two, one for each headlight.
