MagSafe Stand for Secretlab Magnus Pro, Hidden Cable Tunnel + Anchor Inlays
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clean MagSafe stand for the Secretlab Magnus Pro: snap-in puck pocket, hidden cable tunnel, magnetic anchor inlays.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A clean, minimal stand for the Apple MagSafe charger (1st gen, A2140), designed for the Secretlab Magnus Pro desk and its magnetic desk mat.
Puck stays put: it sits in a snug 56.1 mm pocket with six small snap lips, so it won't pop out when you pull your phone off.
Fully hidden cable: the USB-C plug passes through a closed tunnel inside the upright. The cable exits underneath and leaves at the back, with no open channels or clips.
Two anchor inlays: flush pockets in the base hold two Secretlab magnetic cable anchors, which lock the stand to the magnetic mat. No sliding, no rattle.
Size: 60 x 85.6 x 132.3 mm, 18 degree lean back.
PRINT SETTINGS:
Material: PETG (PLA works too)
Orientation: standing upright as in the 3MF, no supports
0.4 mm nozzle, 0.2 mm layers, 4 walls
About 70-80 g of filament, 3-5 h
FIT NOTES:
Fits were tuned on a Bambu Lab H2C with auto flow calibration on. The puck and anchor pockets are intentionally tight. If your printer runs slightly over-extruded, run flow calibration first or scale X/Y up by about 0.2-0.3%.
Assembly: push the USB-C plug down through the tunnel first, then press the puck in until it clicks.