1 / 3
MagSafe Stand for Secretlab Magnus Pro, Hidden Cable Tunnel + Anchor Inlays — image 1
1 / 3

MagSafe Stand for Secretlab Magnus Pro, Hidden Cable Tunnel + Anchor Inlays

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Clean MagSafe stand for the Secretlab Magnus Pro: snap-in puck pocket, hidden cable tunnel, magnetic anchor inlays.

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
16
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

A clean, minimal stand for the Apple MagSafe charger (1st gen, A2140), designed for the Secretlab Magnus Pro desk and its magnetic desk mat.

  • Puck stays put: it sits in a snug 56.1 mm pocket with six small snap lips, so it won't pop out when you pull your phone off.

  • Fully hidden cable: the USB-C plug passes through a closed tunnel inside the upright. The cable exits underneath and leaves at the back, with no open channels or clips.

  • Two anchor inlays: flush pockets in the base hold two Secretlab magnetic cable anchors, which lock the stand to the magnetic mat. No sliding, no rattle.

  • Size: 60 x 85.6 x 132.3 mm, 18 degree lean back.

PRINT SETTINGS:

  • Material: PETG (PLA works too)

  • Orientation: standing upright as in the 3MF, no supports

  • 0.4 mm nozzle, 0.2 mm layers, 4 walls

  • About 70-80 g of filament, 3-5 h

FIT NOTES:

Fits were tuned on a Bambu Lab H2C with auto flow calibration on. The puck and anchor pockets are intentionally tight. If your printer runs slightly over-extruded, run flow calibration first or scale X/Y up by about 0.2-0.3%.

Assembly: push the USB-C plug down through the tunnel first, then press the puck in until it clicks.

Tags