1 / 1
ODROID-M1 NAS Case with 2.5" Drive Bay and 60 mm Fan — zdjęcie 1

ODROID-M1 NAS Case with 2.5" Drive Bay and 60 mm Fan

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Case for ODROID-M1 + one 2.5" SATA drive (7-15 mm) + 60 mm 5 V fan. No supports. v1, not test-printed yet.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
4
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

Enclosure for the ODROID-M1 (with its stock heatsink), one 2.5" SATA drive (7 to 15 mm thick) and a 60 mm 5 V exhaust fan.

STATUS: v1 - checked in CAD against the official board and heatsink dimensions, NOT test-printed yet. Please print the fit test first and share your make or feedback.

Features:

  • No screws in the board: it rests on four posts under the heatsink and the lid holds it down

  • - Drive mounts from the sides or the bottom; slotted holes fit any 2.5" drive

  • - All ports open, plus PWR/SYS LED window and IR window

  • - Side channel for the SATA cables

  • - Prints without supports

Print: PETG, 0.2 mm, 3 walls, 20% infill. Base ~112 g, lid ~38 g.

Hardware: drive 4x M3x4 (side) or 4x M3x5 countersunk (bottom); fan 60x60x10 5 V + 4x M3x16 + nuts; lid 4x M3x10 countersunk; 4 rubber feet; ODROID-M1 SATA data + power cable.

Fan wiring: red to GPIO pin 4 (5 V), black to GPIO pin 6 (GND).

OpenSCAD source: https://github.com/huthaifa-foudeh/odroid-m1-nas-case

Reference dimensions: SBC Model Framework by hominoids.

Tagi