ODROID-M1 NAS Case with 2.5" Drive Bay and 60 mm Fan
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Case for ODROID-M1 + one 2.5" SATA drive (7-15 mm) + 60 mm 5 V fan. No supports. v1, not test-printed yet.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 4
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
Enclosure for the ODROID-M1 (with its stock heatsink), one 2.5" SATA drive (7 to 15 mm thick) and a 60 mm 5 V exhaust fan.
STATUS: v1 - checked in CAD against the official board and heatsink dimensions, NOT test-printed yet. Please print the fit test first and share your make or feedback.
Features:
No screws in the board: it rests on four posts under the heatsink and the lid holds it down
- Drive mounts from the sides or the bottom; slotted holes fit any 2.5" drive
- All ports open, plus PWR/SYS LED window and IR window
- Side channel for the SATA cables
- Prints without supports
Print: PETG, 0.2 mm, 3 walls, 20% infill. Base ~112 g, lid ~38 g.
Hardware: drive 4x M3x4 (side) or 4x M3x5 countersunk (bottom); fan 60x60x10 5 V + 4x M3x16 + nuts; lid 4x M3x10 countersunk; 4 rubber feet; ODROID-M1 SATA data + power cable.
Fan wiring: red to GPIO pin 4 (5 V), black to GPIO pin 6 (GND).
OpenSCAD source: https://github.com/huthaifa-foudeh/odroid-m1-nas-case
Reference dimensions: SBC Model Framework by hominoids.
