PrintDry Pro 3 Filament Holder Upgrade
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Load 3 spools instead of two, on rollers instead of axles! Designed to be easy to print!
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 12
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Modernize your PrintDry Pro system.
The stock unit is space inefficient and spools are painful to load. With this upgrade, users can load three 1 kg spools instead of two, and the unit is generally much more lenient with what spools are compatible.
Instead of using a convoluted 5 piece setup to ready a spool for loading, this upgrade uses rollers, allowing users to simply drop a roll of filament in.
All parts are designed to be printed in decent print orientation and no supports. Exploded diagram included in photos to help with assembly.
Additional required hardware:
(12 ct) 608 2RS Ball Bearings - I bought a 20 pack off amazon for 6.50. Two bearings per roller.
(2 ct) 8x300mm round metal rod. I bought a 2 pack stainless steel rod for 9.50. Material doesnt matter that much. The more important measurement is 8mm, because the bearing fits it. I believe you can go down to around 270mm rod (300 was just easier for me to buy, but they barely fit). I would not suggest going for 1 ft rods. I haven't tried them, but that extra few millimeters may cause them to not fit.
Additional notes:
The rods don't need to be perfect because the filaments don't need precise rolling action in practice. but the two rods should be expected to withstand 85c heating and 4-5 kg sustained load.
Be aware of what youre printing with. I used ASA-CF, which generally has a HDT of over 100C. If you use PETG or a less heat-resistant material, make sure it can handle the heat.
When printing, use plenty of walls. I would suggest 6 walls 25% infill on a 0.4mm nozzle. Infill isn't as big a deal, but don't skimp on walls. Again, the assembly needs to hold 4-5 kgs under heat.