EVA 3 Inlet for 5015 fan parallel to backplate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 5015 fan inlet for EVA 3 where the fan is oriented parallel to the backplate.
- Ocena
- 4,9 / 5
- Polubienia
- 132
- Pobrania
- 1271
- Wydruki
- 5
- Wyświetlenia
- 6883
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 5015 fan inlet for EVA 3 where the fan is oriented parallel to the backplate. Use this part if you have not enough space in the back of your printer for the new fan orientation of EVA 3.
Print one of the three arms to attach the fan on the top left hole to the backplate.
EVA-3-Inlet-5015-Parallel-Arm-Screw
Screw directly into the printed part. You need one M3x10 screw to attach the arm the the backplate and one M3x20 screw to attach the fan to the arm.
EVA-3-Inlet-5015-Parallel-Arm-Heat-Set
Use two M3xD4.6 heatset inserts with a maximum length of 6mm in the arm. You need one M3x10 screw to attach the arm the the backplate and one M3x20 screw to attach the fan to the arm.
EVA-3-Inlet-5015-Parallel-Arm-Hex-Nut
Remove the sacrificial layer from one hole and press one M3 hex nut into the bottom of the printed part. Use another M3 hex nut with a corner pointing down in the other hole. Use one M3x12 screw to attach the arm to the backplate and one M3x25 to attach the fan to the arm.
Warning
If you use this part on the RatRig V-Minion make sure that the right mounting arm of the fan does not colide with the x-axis motor mount. It might be necessary that you trim down the right fan mounting arm.