HexScraper with Magnet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The HexScraper with an embedded magnet for hanging on metal surfaces (metal desk leg, MK3 PSU, etc.)
- Ocena
- 4,714 / 5
- Polubienia
- 33
- Pobrania
- 175
- Wydruki
- 9
- Wyświetlenia
- 1671
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The same great HexScraper, but now with more magnetism! The embedded magnet allows you to hang the scraper on a metal surface, such as a metal desk or the PSU on the side of the MK3/S/S+.
The magnet pocket is sized for a 9.5mm x 3.2mm neodymium disc magnet. I used these. A print pause at the appropriate layer is used to insert the magnet.
The supplied g-codes all include the print pause, use 3 perimeters, and have 1mm - 1.2mm top & bottom thickness.
PrusaSlicer defaults to a 0.2mm first layer height on 0.1mm through 0.3mm layer settings profiles, so I'm not sure that using a 0.1mm-0.2mm layer height really matters much for the end result. I ended up “sharpening” the edge with some sandpaper on a flat surface; coarse grit (~220) followed by fine grit (~2000). After this little bit of post-processing, it's super easy to slide the scraper under things on the print sheet.
I went a little cray-cray with the g-code files, but hopefully you can find something that suits your needs! If not, there's always the model file to slice yourself to your liking.
Change Log:
- 25FEB2023 – Corrected print time error on model overview.