Magnetic Cable Holders. Choose Your GAP!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Organize your cable holders with a choice of gap sizes and number of cables you need to hold. With inserts for magnets.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 433
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
Use 10x3 mm magnets and pauze print at the height just before the hole is covered.
I have so many cables with such a diversity of diameters. So I made a collection of cable holders that fits at least my needs.
The side of the cable holder has a flat area so it is easy to align different sizes.
The gap sizes (measured after printing) are: 2.6 mm. 3 mm, 3.5 mm, 3.9 mm, 4.4 mm
I needed the cable holder with the largest gap to hold my keyboard cable (diameter of 5.6 mm) on my desk, as shown in one of the pictures.
Print settings:
No supports
2 or 3 perimeters
4 top 2 bottom layers
0.2 layer height
+10% infill
Using concentric filled for solid layers and top layer gives the best results for the top curves.
For PrusaSlicer or Super Slicer, setting parameter solid_infill_below_area to 35mm² will save filament and printing time.