1 / 2
Fan shroud for "Noctua LH-L9a-AM4" CPU cooler in "Kolink Rocket" case — zdjęcie 1
1 / 2

Fan shroud for "Noctua LH-L9a-AM4" CPU cooler in "Kolink Rocket" case

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a fan shroud to help the CPU fan suck in cold air from the outside, through the side panels.

Ocena
0 / 5
Polubienia
4
Pobrania
83
Wydruki
1
Wyświetlenia
1696
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

This is a fan shroud to help the CPU fan suck in cold air from the outside, through the side panels. It should just fit through pressure, no mounting hardware or tape needed.

I made it for the "Kolink Rocket" mini-ITX pc case with the 92mm Noctua fan on the LH-L9a-AM4 cooler on an ASUS ROG STRIX B450-I board. Should fit other boards fine well, though.

To adapt it to other cases and fans (only top-down blower style), you'll need to play around with the values in Customizer or OpenSCAD.

Don't make the walls to thin, the outer and inner sides are not perfectly parallel and the slicer may remove parts of them. Check layer view in your slicer.

Print instructions

Category: Computer Summary

This is a fan shroud to help the CPU fan suck in cold air from the outside, through the side panels. It should just fit through pressure, no mounting hardware or tape needed.

I made it for the "Kolink Rocket" mini-ITX pc case with the 92mm Noctua fan on the LH-L9a-AM4 cooler on an ASUS ROG STRIX B450-I board. Should fit other boards fine well, though.

To adapt it to other cases and fans (only top-down blower style), you'll need to play around with the values in Customizer or OpenSCAD.

Don't make the walls to thin, the outer and inner sides are not perfectly parallel and the slicer may remove parts of them. Check layer view in your slicer.

Print Settings

Resolution: 0.2mm

Infill: None needed

Filament: Casee (Cheap) PLA Black
Notes:

I will see how PLA holds up to the heat. Maybe use PETG or ABS instead.

Tagi