Parametric T-Slot Antenna
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A generator for clips to build directional antennas with aluminum extrusion (T-Slot).
- Ocena
- 0 / 5
- Polubienia
- 61
- Pobrania
- 228
- Wydruki
- 1
- Wyświetlenia
- 2184
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution
This is a generator for clips to build directional antennas with aluminum extrusion (T-Slot). It was designed to allow quick prototyping for Quick2Space, check out their project page here: https://bitbucket.org/Quick2space/433mhz-antenna/src/master/
It generates one dipole clip and N rod (director/reflector) clips in a set, ensuring the rods are in the same plane with the dipole, iow the same distance from the aluminum extrusion
It uses a single screw (typically M3 for 15mm extrusion) to both tighten the rod and attach to the T-slot.
It prints as is, no supports required.
The included STL example is for 1515 (MakerBeam XL) and 3/16" rods, and uses M3 10mm screws, but you can "Open in Customizer" and adjust as needed.